HAI by Leviton Releases Controller Firmware 3.11

HAI by Leviton released Version 3.11 Firmware for the OmniPro II, Omni IIe, Omni LTe, Lumina Pro, and Lumina.  Check out the chart below to see what features were added with each firmware update!  What are you missing out on?

Need to update your firmware?  If it's a non-flash board (pre 02/08), then you need to secure the latest firmware upgrade chip.  If you have a newer board, it is capable of remotely upgrading.  View this Knowledge Base article to find out how!

Version 3.11

- Added support for the KNX gateway.
- Added support for the Omni LTe controller.
- Reduced poll rate on Z-Wave locks to extend battery life.

--------------------------------------------------------------------------------
Version 3.10

- Added support for ZigBee shades.
- Added ZigBee LCM power demand.
- Added Support for HTX 2 / GUI Pages to the Extended Setup.
- Added support for ZigBee and Z-Wave locks. 

--------------------------------------------------------------------------------
Version 3.9

Added support for Extended Setup information.

--------------------------------------------------------------------------------
Version 3.8

- Added support for new Leviton Viza RF Zone Controllers.
- Added support for CoolMaster.

--------------------------------------------------------------------------------
Version 3.7

  - Added support for ZigBee units and thermostats.
  - Modified to allow baud rate to be adjusted for Lutron HomeWorks and CentraLite.
  - Added ZigBee Enroll and Disband feature to the "Edit ZigBee Address" dialogs for units and thermostats. 

--------------------------------------------------------------------------------
Version 3.6

- Added support for HAI Hi-Fi 2.

--------------------------------------------------------------------------------
Version 3.5

- Added support for Carrier Infinity / Bryant Evolution thermostats.

--------------------------------------------------------------------------------
Version 3.4

- Added support RadioRA 2.
- Added support for Somfy ILT.
- Added support for baud rates up to 115,200 on serial ports 2 through 4 on the main board.  Port 1 and the Hardware Serial Expander port are limited to 9600 baud.




HAI Blog Admin